- ページ 5

芝生とガーデン用品 AquaScape 77020のPDF 使い方とメンテナンスをオンラインで閲覧またはダウンロードできます。AquaScape 77020 16 ページ。 Pond waterfall filter
AquaScape 77020 にも：取り付け方法とメンテナンス (16 ページ)

ページを印刷する

STEP 7

POSITION THE FILTER

• Position the fi lter along the perimeter of the pond with the

spillway pouring back into the water. The fi lter can also be

positioned on top of a waterproof liner to guide water back

into the pond.

TIP

If needed, use a soil tamper or cinder block to

compact the ground beneath the fi lter, preventing

future settling.

• Use a 3-foot level to ensure the fi lter is level from

side-to-side and tilted forward a 1/4 bubble.

aquascapeinc.com |

CAN (866) 766-3426 |

STEP 8

ATTACH PIPE TO FILTER FITTING

• Attach 1", 1.25", or 1.5" pipe (not included) to the fi tting

at the back of the fi lter. It is recommended to use a hose

clamp (not lincluded) to secure the pipe onto the fi tting.

TIP

In some instances the pipe/tubing may be tight or

diffi cult to connect to the fi tting. If this is the case,

it is recommended to heat the hose with a hair

dryer or dip it for a few seconds in very hot water.

Lubrication such as silicone grease or olive oil can

also be used.

TIP

Use as large of a diameter of pipe as possible

to achieve maximum water fl ow. If using a pipe

diameter larger than the smallest section of the

fi tting, trim off the smaller sections to avoid fl ow

restriction.

Hosetail ready for 1" tubing

Hosetail ready for 1½" tubing

US (866) 877-6637

Hosetail ready for 1¼" tubing

CUT

HERE

STAINLESS STEEL

HOSE CLAMP

CUT

HERE

Installation of stainless steel hose clamp

Kink-Free

Tubing