- ページ 5

冷凍庫 Diamond ERD145のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Diamond ERD145 6 ページ。 Glass door chillers and freezers

Thermostat

The thermostat is placed in the control panel, see fig. 2.0.

The thermostat has been pre-set and in most cases it is not

necessary to adjust the settings.

When turning on the cabinet the display will show the current

temperature in the cabinet.

Display set temperature

Press this key and the display will show the set temperature. Press the key again to

SET

return to normal reading.

Set new temperature:

SET

Press this key and the display shows the set temperature.

Press this key to increase the set temperature.

Press this key to lower the set temperature.

Press this key to save the new settings. The display will flash with the new value and

SET

will then return to normal reading.

Alarm codes

PF1—Flashing in the display: indicates that the cabinet sensor is defective. The cabinet will

strive to keep the set temperature until it has been repaired.

PF2—Flashing in the display: indicates that the evaporator sensor is defective. This does not

influence the operation of the cabinet, but should be repaired as soon as possible.

DISTRIBUTED BY:

SOUTHERN

p: 0800 503 335 | w: www.southernhospitality.co.nz

HOSPITALITY

Fig 2.0