- ページ 2

照明器具 AQUASONIC DILUVIOのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。AQUASONIC DILUVIO 2 ページ。 Face ring

Place the speaker on a non-abrasive surface with the sound lens facing up. Hold the face ring above the

sound lens, allowing the clamp tabs to fall open. Set the face ring against the mounting gasket, ensuring

each clamp tab is on the outside of the mounting gasket. While placing the face ring on the gasket tuck the

gasket in so no red shows. Hold the entire assembly together and flip it over, place it on the non-abrasive

surface as shown in the third picture below. Carefully position the face ring so it is centered over the sound

lens.

Place the wire clamp under each clamp tab, verifying the nut and bolt adjuster is accessible when the

clamp is placed under the tabs. Insure the mounting gasket and face ring are still evenly centered. Use a

wrench and a Phillips screwdriver to tighten the wire clamp. When fully tightened, the wire clamp should

be firmly seated in each clamp tab and the speaker should be secure. Pick up the assembly and insure it is

still properly centered in the face ring. If not, loosen the wire clamp and adjust.

Take the end of the speaker wire and pull it through the conduit hole in the back of the niche. For future

speaker servicing, leave enough speaker wire in the niche to allow the speaker to be placed on the pool

deck.

Note: In actual applications, the niche will already be mounted in the wall of the pool.

Carefully set the lock tab located on the bottom of the face ring behind the receiving plate located on the

bottom of the niche. Align the bolt/rubber washer on the face ring with the threaded receiving hole on the

niche. Attach the trim ring securely to the niche by gently tightening the bolt. You are now ready to connect

the speaker to your audio system.

Bolt