- ページ 15
ビデオカメラ Panasonic WVNW964 - NETWORK CAMERAのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Panasonic WVNW964 - NETWORK CAMERA 32 ページ。 Ip video cameras
Panasonic WVNW964 - NETWORK CAMERA にも： 取扱説明書 (21 ページ), サービスマニュアル (28 ページ), パンフレット (2 ページ), 参考 (2 ページ), 参考 (2 ページ), 仕様 (2 ページ), 統合ノート (8 ページ)
ページを印刷する
Installations/connections
Precautions
• Make sure that the place you are installing the camera is strong enough to support it. If it is not strong enough,
then the camera may fall and hurt someone.
• The following steps of installation and connection work should be done by qualified service personnel or sys-
tem installers and should conform to all local codes.
• Be sure to turn the power off before installation and connection.
• Do not install the camera near the air outlet of an air conditioner.
Mounting the Camera
Ceiling mount
The figure shows an example of
the camera mounted on a ceiling
with a locally procured bracket.
Refer to the instructions included
with the bracket for filling gaps
and holes with waterproof materi-
al.
G Construction
40 1-1/2B deep 30 MAX
PT11 crest (taper pipe thread)
40 1-1/2A deep 30
MAX
(60) 25
PT11 crest (parallel
pipe thread)
G Assemble procedure
1. Preparations
(1) Procure a ceiling mount bracket.
(2) To prevent the camera from falling, use a mounting
a bracket to which a safety wire can be attached.
(3) Installation Surface
Caution: Consult an expert on the load bearing
capacity of the installation surface and struc-
ture. If the surface is not strong enough, the
camera may fall down. Refer to the product
specifications for weights.
85
Prepare appropriate hardware (e.g. wall nuts,
anchor bolts, etc.) for fixing on the installation sur-
face.
2. Disassembling the Camera
(1) Remove the upper base from the camera by loos-
ening 3 screws. The screws that are removed need
to be used during reassembly. Be careful to not
lose them. Turn the upper base and separate it.
* Special screw (mounting screw): Use a hexagon
wrench for the hexagon screw (M6).
(2) Remove the attachment pipe from the upper base
by loosening 4 screws.
* Special screw (mounting screw): Use a hexagon
wrench for the hexagon screw (M6).
x3
x4
15