- ページ 4

スピーカー Diamond Audio D652のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Diamond Audio D652 4 ページ。 D series

MIDRANGE MOUNTING
Determine a location in the door that will accept
the size of your new speaker. Remove the door
panel from the door and check for clearance in
the intended speaker location while operating
window all the way up and down. Avoid cutting
any structural metal to mount the speakers or
to accommodate additional depth. If depth or a
flat surface mount are an issue, please seek the
skills of a professional installation technician.
If you are mounting the speakers in the rear of the
vehicle, there are often two options for achieving
a good mount. Some speakers mount from the top
side (from the interior) while other applications have
the speakers mounted from the bottom side (from
the trunk). In either case, a flat mounting surface and
a good seal are still extremely important.
TWEETER MOUNTING
When flush mounting tweeters, make sure the desired
location can accommodate the hole size and depth
required. Mount the cup using provided hardware. Mount
surface cup at desired angle with provided screws in
tweeter mounting kit. Route speaker wires through
tweeter cup, connect tweeter to wires, and snap tweeter
into cup by aligning the notches.
Mounting Hole size: 1.36" (34.5mm) Dia.
©2014 Diamond Audio. All rights reserved.
(a division of CV & DA Holdings, lnc.)
D Speaker Manual 2013.indd Spread 4 of 4 - Pages(4, 5)
SYSTEM CONNECTION
D65C
Each D crossover has a tweeter attenuation jumper and a phase adjustment located under the
removable cover. Choose "0" or "-2dB". If the tweeter is significantly closer to the listener than the
midrange, this adjustment should improve the frequency level balance.
D365C
Each DAT3X crossover has a tweeter phase switch located under the removable cover. Choose "0"
or "180". This adjustment may improve frequency response depending on the tweeter mounting
location relative to the midrange.
DAT3X
INPUT
WOOFER
MID
TWEETER
©2014 Diamond Audio. All rights reserved.
(a division of CV & DA Holdings, lnc.)