- ページ 4

アンプ Diamond Audio DXM SeriesのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Diamond Audio DXM Series 13 ページ。 Digital amplifier

SYSTEM OVERVIEW

A crossover is a device that removes unwanted

frequencies from a speaker or ampliﬁer. A

Tweeter can easily be destroyed by bass notes

if they are not ﬁltered out. Likewise a sub-

woofer will not sound natural if it is playing

midrange notes. A crossover remove these

sounds from the speaker speaker. As you might

guess, carefule adjustment in need to ensure

that all the speakers are playing at the right sound that you

are left with no "holes" or low spots in the frequency response.

DIAMOND MOTORSPORT Series ampliﬁers

have an adjustable bass boost. Begin your

adjustments at low volume. If you do not hear

any improvement then woofer does not need

any BASS BOOST. The Low Pass Filter (LPF)

must be switched on for the bass boost to

activate. Use Bass Boost carefully.The demands

on power output are tremendous. Try to

minimize the use by changing woofer position or the enclosure size.

This ampliﬁer is a multi channel ampliﬁer

design. Meaning it has more than one

channel of speaker outputs. It is equipped

with thick wire cable for speaker

connection carefully and neatly strip the

wire back and twist the exposed leads

and solder them into the Ampliﬁer's

wires while being careful that there is

no loose or frayed strands of wire and put heat shrink tube to seal the connection points

until the wire is tightly secured in place. If the wires ever come to in contact with each other

the ampliﬁer will go into protection. Know your total ohm load before you make any connections.

CROSSOVER

SELECT SWITCHER

ADJUSTABLE

BASS BOOST

CROSSOVER

FREQUENCY ADJUST

MULTI CHANNEL

OUTPUT