- ページ 6

カー・アンプ Diamond Audio Technology D7401のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Diamond Audio Technology D7401 11 ページ。

AMPLIFIER BLOCK DIAGRAM

to the bare metal using a bolt, star washer and nut. Seal the area from above

(D7401)

and below to prevent rust. Strip approximately 1/2 inch of insulation from the

other end of the cable and insert it into the ground block on the amplifier and

tighten the Allen screw.

ENDPLATE DIAGRAM (POWER/GROUND REMOTE)

For multiple amplifier systems, a ground distribution block is recommended.

Cut a length of cable long enough to go from the ground distribution block to

the amplifier. Strip approximately 1/2 inch of insulation from each end of the

ground cable. Insert one end into the ground distribution block and tighten the

Allen screw. Insert the other end of the cable into the ground block on the

amplifier and tighten the screw (A ring terminal may be used here). Repeat for

each amplifier installed. Run a cable (the same gauge as the main power cable)

from the ground distribution block to the negative terminal of the system

battery.

Your D7 Professional Reference Series Amplifier is designed to accept up to

4 gauge power and ground cable when using the Direct (stripped wire end)

Connection method.

When using ring terminals to attach the power and ground, cables of up to 1/

0 gauge can be used. Please refer to the Power Cable Gauge Chart (page 7) for

the minimum recommended wire gauge.