- ページ 6

カースピーカー Diamond Audio Technology CM361のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Diamond Audio Technology CM361 10 ページ。 Cm3 series convertible speaker systems

ページを印刷する

Flush Tweeter Mounting

1. Remove tweeter from bridge follow-

ing bridge disassembly instructions.

2. Cut a 1.625" diameter hole in desired

location. (make sure it is a flat sur-

face)

3. Insert Flush mount cup screw through

center hole in flush mount cup.

4. Twist flush mount cup spring onto

screw.

5. Push entire assembly through hole cut

earlier and tighten flush mount screw

till cup is held firmly in place by the spring.

6. "Snake" tweeter leads through the wire holes in the cup.

7. Snap tweeter into cup by aligning the notches on the tweeter with the

tabs in the cup. (do not push on the center of tweeter grill)

8. Attach provided tweeter speaker wire to tweeter leads taking note of

polarity. (wire w/ white stripe is positive)

Crossover Detachment

(for remote crossover mounting in component systems)

1. Remove screw located at the bottom of

the crossover.

2. Gently remove crossover by pulling

downward.

3. Mount crossover to wire harness or some

stable location using provided zip tie.

1. To reattach, line up terminal holes on

crossover with terminals on the mid bass

speaker and gentle push upwards.

2. Replace crossover mounting screw and

tighten. (do not over tighten)

Mounting

Spring

Clip

Coaxial Wiring

1. Mount bridge to mid bass following

the bridge mounting instructions.

1. Connect speaker wire from source to

terminals on crossover (already

mounted on speaker) and play.

Cup

(align tab and slot)

Tweeter

Screw