- ページ 9

浄水器 AquaSure AS-F110CBのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。AquaSure AS-F110CB 12 ページ。 Whole house

SYSTEM MAINTENANCE

Note: Depending on usage and water quality, you might have to change your filters every

4 - 8 month or 6 - 12 months. It is recommend to change your Stage 1 filter at least every

4 - 6 month for areas with bad water quality.

STEP 1.

Shutting off the Supply Water

Caution! Before working on any system maintenance, prepare clean cloth or microfiber towel

to wipe off excess water that might spill during the filter replacement or system maintenance.

1. Turn the main water supply valve completely off by rotating it clockwise.

2. Turn on the nearest faucet to release any excess water and pressure that is built up inside

the pipe.

STEP 2.

Removing the Filter Housing

1. Press the red pressure relief button on the top of the housing cap to relief any pressure

built up inside the system.

2. Using the housing wrench and turning it to the left to loosen

3. Discard the old filter and clean the inside of housing and cap with warm water.

Caution! Do not use any chemical to wash the housing.

STEP 3.

Install the New Filter

1. Unwrapped the filter and place it inside the housing and make sure the housing is

centering on the stand pipe.

2. Check the o-ring for cracks or damage. Replace o-ring if it is damaged.

3. Screw on the housing with filter inside to the corresponding head by turning it from left to

right using the supplied housing wrench.

Note: Make sure the o-ring is inside the housing and do not over tightening the housing.

STEP 4.

System Startup

1. Turn on the main water supply valve fully by turning it counterclockwise

2. Check for leaks

3. Turn on the nearest faucet and let the water run for 10 minutes to release any trapped air

bubble or carbon fine if a carbon filter is installed.

AQUASURE

FORTITUDE V SERIES