- ページ 3
室内装飾品 3branch KURVEのPDF 組立説明書をオンラインで閲覧またはダウンロードできます。3branch KURVE 6 ページ。 Desk w/hand crank adjustable height "t" base
ページを印刷する
NOTE: THE FOLLOWING ASSEMBLY INSTRUCTIONS
APPLY TO ALL SHAPES & SIZES OF KURVE DESKS.
STEP 1:
REMOVE ALL PACKING MATERIAL FROM DESK TOP PANEL,
APRON/SUB-TOP ASSEMBLY, & BASE PARTS & TOP.
*CAUTION: TWO PEOPLE REQ'D FOR DESK ASSEMBLY TO
AVOID DAMAGE TO DESK PARTS & PERSONAL INJURY!
STEP 2:
LAY CLEAN COVER ON FLOOR TO PROTECT FLOOR &
DESK PARTS.
APRON/
SUB-TOP
ASSEMBLY
TOP PANEL
STEP 4:
LAY APRON/SUB-TOP ASSEMBLY ON BOTTOM FACE OF PLASTIC
LAMINATE TOP PANEL & CENTER.
NOTE: THERE IS AN APPROXIMATE 1" TOP OVERHANG PAST THE
APRON/SUB-TOP ASSEMBLY.
NOTE: APRON/SUB-TOP ASSEMBLY MAY SHIP WITH TOP PANEL
ALREADY ATTACHED. IF SO, SKIP STEPS 4 & 5.
KURVE COLLECTION
3branch
product design solutions
CLEAN COVER
LAMINATE
TOP PANEL
STEP 3:
LAY PLASTIC LAMINATE TOP PANEL ON CLEAN COVER WITH GOOD FACE
TURNED DOWN.
NOTE: STEPS 3, 4 , & 5 ARE FOR PLASTIC LAMINATE TOPS ONLY.
SOLID SURFACE TOPS WILL BE MOUNTED TO APRON/SUB-TOP
ASSEMBLY WITH SILICONE ADHESIVE AFTER BASE END ASSEMBLIES
ARE ATTACHED. SEE STEP 19.
#8 X 1 1/2" PFH
STEP 5:
ATTACH APRON SUB-TOP ASSEMBLY TO TOP PANEL WITH
#8 X 1 1/2" PFH SHEET METAL SCREWS. INSERT SCREWS INTO
COUNTERSUNK HOLES LOCATED IN SUB-TOP & THREAD INTO
BOTTOM FACE OF TOP PANEL.
NOTE: QUANTITY OF SCREWS WILL VARY WITH SIZE & SHAPE OF DESK.
*NOTE: DO NOT ATTACH APRON/SUB-TOP ASSEMBLY TO ANY SOLID
SURFACE TOP WITH SCREWS!!! SOLID SURFACE TOPS WILL BE
ATTACHED TO APRON/SUB-TOP ASSEMBLY WITH SILICONE ADHESIVE
AFTER BASE END ASSEMBLIES ARE ATTACHED TO APRON/SUB-TOP
ASSEMBLY. SEE STEP 19.*
DESCRIPTION:
P 847.291.3900
F 847.291.3901
www.3branch.com
DATE:
09.23.21
PLASTIC
SCREWS
KURVE DESK W/HAND CRANK ADJUSTABLE
HEIGHT "T" BASE
ASSEMBLY INSTRUCTIONS
DWG #
SK-KU-DESK-ADJT-ASSEMBLY-01
BACK EDGE OF
TOP PANEL
REV #
0
SHEET
3 OF 6