- ページ 11

ダイビング機器 aquata Dry Diving SuitのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。aquata Dry Diving Suit 20 ページ。

2. The valves must be screwed in the suit, if not already done by the factory. To obtain an

optimal sealing of the valves use small quantities silicone (construction silicone, no sili-

cone grease) in the outer channel. Just fill it up (see diagram). Then you screw the valves

tightly into the suit. Avoid under all circumstances that the silicone comes into the thread.

Otherwise later the valve cannot be removed. Let that the valves one day dry. The valve

can be replaced now nevertheless if necessary. The valves used by us are manufactured

with highest accuracy. In order to receive the full operability, we recommend however an

annual check from your dealer. The provided hose has a UNF 3/8 " connection for the

second stage of regulator (low pressure).

The internal ring in the rubber washer serves the enlargement of the valve hole. The rub-

ber is cut out if you use another manufacturer valves for example Apex. With the "Sitech"

valves supplied by us this part is not taken out. For the removal of the valves normally firm

Inflator O-Ring Lubrication - Note to aquata valves

STEP 1: Remove cover from backnut.

STEP 3: Remove button from inflator body.

Lubricate the two o-rings.

STEP 5: Re-insert e-clip back onto the button.

STEP 2: Remove e-clip with a small screw

driver.

STEP 4: Re-insert button into the valve body.

STEP 6: Assemble cover back onto the

backnut.

02| EN