- ページ 2

車椅子 Aquatec BelugaのPDF 組み立て説明書をオンラインで閲覧またはダウンロードできます。Aquatec Beluga 2 ページ。 Change of actuator
Aquatec Beluga にも：組み立て説明書 (4 ページ), 組立手順 (3 ページ), 組み立て説明書 (4 ページ)

ページを印刷する

ASSEMBLY INSTRUCTIONS

Assembly of Headrest AQUATEC BELUGA

WORK SAFETY:

It is imperative that you observe the accident prevention regulations of the tools and machines

used. In drilling the backrest take care not to injure your fingers. Use an underlay when drilling,

e.g. an old wooden board. Make sure the twist drill is at right angles to the surface.

Drilling diagram:

ASSEMBLY:

Screw the mountings (part 1) to the back of the backrest with the flat-headed screws (see

picture 1 below).

Button on the backrest cover again.

If not already pre-assembled, pull the headrest cover (part 4) over the bracket (part 3) and

fasten with Velcro fastener.

Insert the bracket (part 3) into the screwed on mountings. (Assembly completed).

The height adjustment of the headrest to correspond to the size of the person is done by pulling

up or pressing down the bracket complete with cover (parts 3 and 4) in the mountings (part 1).

Picture 1 (from above)

Updated: 01.01.02/Marketing

16126 Assembly headrest Beluga

Page 2 of 2

V/Allgemein/Montage/Montageanleitungen/

Deutsch/Beluga/Montage Kopfstütze