- ページ 4

水ポンプ Aquatec HydroPro HZ2010のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Aquatec HydroPro HZ2010 13 ページ。 Air pumps

ページを印刷する

PRODUCT SPECIFIC SAFEGUARDS

• Be sure the air pump itself is not submersed in

water.

• The air pump is designed to be used in garden

pond or aquarium applications. It is not to

be used in any other manner or purpose. Do

not use the pump in, or in conjunction with,

any chemicals such as a solvent or gasoline or

flammable gases. The pump is designed to

pump clean atmospheric air only.

• Every air pump may eventually "wander" or

"creep" due to its own vibration. Avoid this by

placing it on an entirely level and flat plane. We

recommend securing it with some wire or cable

tie to anchor the bottom of the air pump.

• Hydropro air pumps are cooled by air flowing

through the inside of the motor body chamber.

If the air flow becomes restricted it will overheat

and could cause permanent damage to the

electrical components internally. In the event

that the tubing provided isn't long enough,

keep in mind that large tubing size is strongly

recommended to deliver adequate flow over

longer distances.

INSTALLATION & MAINTENANCE

The Aeration Kit is designed for oxygen enrichment

via the provided air stones and the airline. For your

convenience the Hydropro Aeration Kits include,

but are not limited to the following:

1. 50mm round air stones (x2)

2. Clear airline tubing (x2)

3. Spare rubber diaphragm set (for future

maintenance)

4. Plastic check valves (x2)

Start by removing entire contents from aeration kit

carton. Next unroll the clear airline tubing needed

for your application. Tubing can easily be cut to

any length using cutters or a knife. (NOTE: Always

use the minimum amount of tubing needed for

your application, so as not to put needless pressure

HPRO Air Pump Z2010_Z4010 Instructions.indd 4

This reduces friction loss within the tubing itself.

The air pump air filter needs to be cleaned

regularly to prevent the pump becoming

clogged with dust, causing the airflow to reduce.

In this event motor burnout is not a warrantable

event.

• Never leave the air pump running without

sufficient counter pressure (air stones). This

may potentially cause the rubber diaphragms

to wear or tear prematurely. The overall

performance will also be greatly reduced.

• The Hydropro air pumps are designed to operate

at a maximum depth of 4Ft/1.2m of water.

Greater depth will increase diaphragm wear.

• As with all air pumps, wear and tear will

inevitably occur over time. Hydropro air pump

diaphragm assemblies are easy to replace. Only

use original Hydropro parts and accessories for

the unit. Check the diaphragm replacement

instructions and detailed diagrams later on in

this manual.

on the air pump which could cause premature

failure.)

Now locate the two air stones and push one

of the ends of each airline tubing roll onto the

plastic ports on both air stones. Then connect the

remaining ends of each roll directly onto each of

the two ports on air pump.

Place the air stones in the water and if desired,

weigh down the airline with suitable weights (e.g.,

fishing weights, rocks, aquatic plants, etc.) to avoid

flotation. For best results air stones should be far

enough apart to allow the maximum amount of

water movement in the pond or water feature.

V I S I T A Q U A T E C E Q U I P M E N T . C O M

22/2/19 11:07 am