- ページ 3
メディア・コンバーター 3C Concept TC-SPLITのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。3C Concept TC-SPLIT 12 ページ。
ページを印刷する2 – Technical Characteristics
Parameter
Module
V_EXT
Max supply current
Power
Supply current @24V (1)
Max supply current, 5V (+V_ENC)
supply current V_EXT (1)
Max Frequency (differential)
Counting
Max Frequency (unipolar)
Max propagation time
Input impedance
Nominal input current
Inputs (5V)
Min. voltage for NL1 (2)
(input switch ON)
Max voltage for NL0 (2)
Max allowed voltage
Input impedance
Nominal input current
Inputs (24V)
Min. voltage for NL1 (2)
(Input switch OFF)
Max voltage for NL0 (2)
Max allowed voltage
Max output current
Output (5V)
Min. voltage for NL1 (3)
(INT or EXT Power)
Max voltage for NL0 (3)
Max output current
Output (24V)
Min. voltage for NL1 (4)
(INT or EXT Power)
Max voltage for NL0 (4)
Size
Others
Protection rating
Operating temperature (5)
Notes:
(1) No load on A/B/Z outputs, no encoder powered
(2) NL1: Logic level 1 (active), NL0: Logic level 0 (inactive)
(3) On 5mA load
(4) On 10mA load, supposing 24Vdc power, if not Vo= Vpower -3V
(5) No condensing
Use shielded multipair cables.
Each pair must be affected to a signal and its complement (example: A+, A-). Cable
shielding should be tied to earth on the electric box. As a good practice, you should
separate power cable from instrumentation signals. Power cable cross-section should
be of sufficient size if module is powered by 5Vdc (avoid this if distance is superior
greater than 5 meters)
3C Concept S.A.S
TC-SPLIT USER MANUAL
Type
3
Pinout
Value
P3.1
10 à 30
Pn.8
4.5 à 30
P3.1
250
P3.1
50
P1.8
200
Pn.8
25
A/B/Z
1000
A/B/Z
250
A/B/Z
1
P1 (1-6)
700
P1 (1-6)
5
P1 (1-6)
2.6
P1 (1-6)
1.5
P1 (1-6)
8.0
P1 (1-6)
4000
P1 (1-6)
5
P1 (1-6)
10
P1 (1-6)
5
P1 (1-6)
30
Pn (1-6)
25
Pn (1-6)
3.0
Pn (1-6)
0.8
Pn (1-6)
25
Pn (1-6)
21
Pn (1-6)
0.8
130x101x18
IP20
-20/+60
TC-SPLIT_MANUEL_EN_105.DOCX
3
Unit
VDC
VDC
mA
mA
mA
mA
KHz
KHz
µs
Ohms
mA
V
V
V
Ohms
mA
V
V
V
mA
V
V
mA
V
V
mm
°C