- ページ 5

グラインダー Diamond Group The piranha IIのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Diamond Group The piranha II 12 ページ。 Tungsten grinder

5. UNPACKING & MOUNTING

The first thing you should do is check for shipping damage. Diamond Ground Products, Inc. takes great pride

in producing quality products. If for some reason you find anything to be defective, please contact the Service

Department at (805) 498-3837 and we will work with you to rectify the problem to your satisfaction.

After unpacking the box you should have these items:

• The Piranha II Tungsten Grinder.

• Three Allen wrenches, sizes 3/32", 7/64" & 1/8" for replacing wheels.

• PII Manual

• Pin Vise

Mounting of the grinder is as follows. Place the unit on a flat surface allowing enough space for the operator to

work in. This also provides proper ventilation. Make sure the power switch is in the off position and plug it into

the electrical outlet. Switch the power on and the unit is ready to operate.

ADJUSTING HANDLES

The set up procedure for the included angle may

require the use of both adjustment handles, which are

listed above as A and B. When handle A is loosened, it

allows you to rotate the Universal Collet Arm to choose

the included angle that you would like to grind your

tungsten. Handle B allows you to adjust the location at

which the tungsten will touch the wheel.

Tip Flat Gauge depth is set with Knob C and locked in

place with Nut D.

THE SET UP PROCEDURE

With the power turned off, select the included angle you

would like to grind by:

1) Loosening Handle A

2) Turning the Collet Arm on its axis until the Pointer is

directed at the angle on the scale you desire.

3) Re-tightening Handle A.

Next, put the tungsten at the diameter you plan to use

through the proper sized collet hole on the universal

collet and observe the height at which the tungsten will hit the wheel. For setting up your first tungsten on a

wheel, make the height as close to the top of the wheel as possible by:

1) Loosening Handle B.

2) Slide Collet Arm up to desired position.

3) Re-tightening Handle B.

The setup in now complete. After grinding numerous tungstens, you will wear a groove on the wheel. At this

point, adjust Handle B again and move the contact point down a very small amount to a fresh spot on the wheel.

Page 5

Document: DGP-MANUAL-P2 | Piranha II Product User Manual | Released: 5/13 Rev. C