- ページ 27

デジタルカメラ Panasonic AW-HEA10KEJのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Panasonic AW-HEA10KEJ 34 ページ。 Control assist cameras
Panasonic AW-HEA10KEJ にも：据付・取扱説明書 (40 ページ)

ページを印刷する

Troubleshooting

The following are normal and not indicative of any problem.

The subjects appear distorted

When the flash is fired during

shooting, only the top or bottom of

the screen becomes lighter

Power

Symptom

No power

Web screen

Symptom

Web screen cannot be accessed

• A subject that moved across in front of the camera quickly may appear slightly distorted because a MOS is used

for the unit's image sensor, but this is not indicative of any problem.

• With a MOS image sensor, the shooting timing differs slightly between the top left and bottom right of the screen.

This means that when the flash is fired, the bottom of the screen will become lighter in the field concerned and

the top will become lighter in the next field. This is normal and not indicative of any problem.

• When the status display lamp is off, power is not being supplied or the unit is

turned off.

→ Correctly connect the AC adaptor and the power cord.

→ Press the power button on the unit.

• If you turn off the unit with the power button of the unit, the unit cannot be turned

on from the Web screen. Press the power button to turn on the unit.

• Is the LAN cable connected securely to the IP control LAN connector?

• Is the network cable for the PoE (IEEE802.af) compatible power supply device and

the unit connected properly?

• Power may not be supplied if the total power limit is exceeded on power supply

devices that allow connections to multiple PoE terminals.

→ Refer to the operating instructions for the PoE power supply device.

• Check the system requirements of the Web screen.

• Is a LAN cable of category 5 or higher connected?

• If the <LINK/ACT> LED of the LAN connector for IP control is off, a connection

has not been correctly established to the LAN or the network of the connection

destination is not working properly.

→ Check the LAN cable for a contact failure, and check the wiring.

• Is the power on?

→ I f the unit's status display lamp is off or lit orange, the unit is not on.

• Has a valid IP address been set in the unit?

• After changing the unit's IP address, enter "http://New IP address/" in the address

bar of the Web browser.

• Has the wrong IP address been accessed?

→ Check the connections by following the steps below.

For Windows:

Using the Windows command prompt, execute > ping [IP address which has been set

in the camera]. A reply returned from the unit signifies that there are no problems in

operation.

If a reply is not received, try following operation:

1 Press the <INIT> button to initialize the unit's network settings.

2 Start the Web setup screen and then configure the network settings again.

For Mac:

Using the OS X terminal, execute > ping -c 10 [IP address which has been set in

the camera]. A reply returned from the unit signifies that there are no problems in

operation.

If a reply is not received, try following operation:

1 Press the <INIT> button to initialize the unit's network settings.

2 Start the Web setup screen and then configure the network settings again.

Cause and solution

Reference pages

– – –

Installation Instructions

Reference pages

page 8

page 12

page 24

page 16

– – –