- ページ 11
デジタルカメラ Panasonic AW-HEA10WEJのPDF 据付・取扱説明書をオンラインで閲覧またはダウンロードできます。Panasonic AW-HEA10WEJ 40 ページ。 Control assist cameras
Panasonic AW-HEA10WEJ にも： 取扱説明書 (34 ページ)
ページを印刷する
How to install and connect the unit (continued)
4.
Mount the unit.
• Align the hole for checking the positioning of mount bracket B with the positioning mark of the unit.
• Align the bottom insertion holes of the unit with the camera insertion protrusions of the mount bracket and then push the unit and bracket together
firmly and rotate the unit by approx. 20° in the direction of the arrow.
• Secure the unit and mount bracket B with the supplied bracket mounting screw B (M3 x 6 mm).
Hole for checking
the positioning
On the mount
bracket:
Camera insertion
protrusions (3
places)
On the unit:
Bottom insertion holes
(3 places)
Positioning mark
<NOTE>
• Use only the screws supplied. Do not use any other screws.
• Check that the unit has been mounted securely with no tilting or wobbling.
• Be sure to secure the unit and bracket with the bracket mounting screw B before connecting any of the cables.
5.
Check the mounting.
Check out the following points.
• The bracket mounting screw B must be attached properly.
• The unit must not tilt, and it must be mounted exactly.
• The unit must be securely installed.
6.
Connect the rear panel connectors.
Anchor the AC adaptor cable in place using the cable clamps.
<NOTE>
• Two cable clamps are available: one at the top and one at the bottom of the connector panel. Use the most suitable method depending on the
installation method and positioning of the cable.
Approx.
20°
Bracket mounting screw B (M3×6 mm)
Cable clamp
LINK/
100BT
ACT
USB 2.0
5.0V IN
DEVICE
INIT
10BASE -T/
100BASE- TX
AC adaptor cable
11