- ページ 12

デジタルカメラ Panasonic BM-ET300のPDF セットアップマニュアルをオンラインで閲覧またはダウンロードできます。Panasonic BM-ET300 16 ページ。 Iris camera

ページを印刷する

z Detaching the Cover

Detach the front cover from the iris camera by removing the

tamperproof screws with the supplied tamperproof screw

driver tool.

The tamperproof screw holes are

inclined to the front side approx. 15

as you can easily fasten the screws

while the iris camera is mounted to the wall.

Note: Be sure to shut down the power supply before

detaching the front cover from the iris camera. If the

power is being supplied when the front cover is

detached, the iris camera will enter the "tamper detec-

tion" mode and the buzzer will beep. In case the power

supply cannot be shut down, detach the front cover

from the camera and cancel the "tamper detection"

mode by moving Setup Switch 3 to ON. The buzzer

sound will be stopped.

x Setup Switch Setting for Setup

Before starting the setup, move Setup Switch 3 to ON to

cancel the "tamper detection" mode. (Set all the other

switches to OFF.)

Approx. 15

Remove the tamperproof screws with the

Tamperproof screws x 2

supplied tamperproof screw driver tool.

ON (Upper side)

1 2 3 4

c Connection between the Iris Camera and

Setup PC

Connect the iris camera and setup PC with the exclusive

setup cable supplied to the administration software.

Attach the round connector of the cable to the setup cable

connector of the iris camera, and then attach the D-sub 9

pin connector of the cable to the serial port of Setup PC.

(When attaching the round connector to the iris camera,

direct the cable to the left of the connector.)

v Supplying the Power to the Iris Camera

Turn on the power of the external power-supply device.

Wait until the guide and result indicator goes out.

b System Setup

The following is how to boot the setup software.

1. Double-click "BM-ET300 SetupSoftware" in the

folder designated at the time of installation.

"BM-ET300 Login" window will appear.

2. Select the COM port to which the iris camera is

connected, and then enter the password.

• Available characters (Capital and small letters are dis-

tinct.): ABCDEFGHIJKLMNOPQRSTUVWXYZabcdefghij

klmnopqrstuvwxyz0123456789

• 6 to 16 characters are available.

• Default password: BMET300

When the password is accepted, the current setting is

read from the iris camera into the setup software. (The

reading may take a few seconds.)

After the setting is read into the software, the

"Completed." window will appear. When you click on

"OK", the "BM-ET300 setup software" window will

appear. (Refer to p. 13.)