- ページ 3

デジタルカメラ Panasonic CF-U1 seriesのPDF 補足説明マニュアルをオンラインで閲覧またはダウンロードできます。Panasonic CF-U1 series 12 ページ。 Supplementary instructions for hspa modem
Panasonic CF-U1 series にも：仕様書 (2 ページ), 補足説明マニュアル (12 ページ), 補足説明マニュアル (8 ページ), 補足説明マニュアル (17 ページ), 追加情報 (25 ページ)

ページを印刷する

Setting for Barcode Reader

The following menu opens by clicking

Connection to Barcode

(Power Saving Mode)

Connection to Barcode

(Always-On)

Disconnect Barcode Module

Confirmation Message On

Allow Code 39

Packet Mode

Exit 2D Barcode Key Emulator

The confirm message is closed in the following cases.

When five seconds pass from the display message.

•

When the [Close] in the message window is clicked.

•

When the trigger button is pushed again.

•

NOTE

When the computer enters Sleep (Model with Windows Vista)/Standby (Model with

Windows XP) or Hibernation in Power Saving Mode or Always-On mode, the Barcode

Reader is disabled. [Barcode Module was disconnected by changing the power status]

message appears at the next resume timing.

In Power Saving Mode, click [OK] to reconnect with the Barcode Module.

•

In Always-On mode, click [OK] and select [Connection to Barcode (Always-On)] again

•

from the above menu to reconnect with the Barcode Module.

When the computer is shut down in Power Saving Mode or Always-On mode, the

Barcode Reader is disabled.

In Power Saving Mode, just turn on the computer to reconnect with the Barcode

•

Module.

In Always-On mode, the Barcode Module is not reconnected only by turning on the

•

computer. Select [Connection to Barcode (Always-On)] again from the above menu.

The

icon may not appear when you start up the computer for the first time. In this

case, restart the computer.

icon on the notification area.

To reduce the power consumption, stop barcode reader

connection within 1 minute after reading a barcode.

Keep barcode reader active even after reading a barcode.

Stop barcode reader connection in Always-On mode or

Power Saving Mode.

If the trigger button is pressed in Power Saving Mode, "Push

Barcode Trigger again to enable Barcode." message is dis-

played to prevent operational errors.

Allow Code 39 type barcode. You can change the setting

by scanning Enable/Disable of Code39 (

Receive barcode decode data in packet mode.

Exit barcode reader operation.

Page 7).