- ページ 4
GPS Diamond Kinetics SwingTracker DKST02のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Diamond Kinetics SwingTracker DKST02 14 ページ。
Diamond Kinetics SwingTracker DKST02 にも： ユーザーマニュアル (11 ページ)
ページを印刷する
PACKAGE CONTENTS
What comes in the Box
● Sensor
● Sensor Mount
● Sensor Strap
● Charging Station with USB connection
● Storage Pouch
Works with the free SwingTracker iOS App
USING YOUR SWINGTRACKER SENSOR
Attach SwingTracker Sensor to your Bat
Confirm that the sensor is firmly secured by nudging it. If the sensor mount is
loose, you can secure the mount using the second hole at the top of the
strap.
Your SwingTracker sensor should be attached to your bat on the knob end
only using a SwingTracker strap. Do not use any other mechanism to attach
your sensor to your bat; doing so will void the manufacturer's warranty.
Turn On your Sensor
With the sensor attached, tap the bottom of bat on the ground twice to turn on the
sensor. The light will begin to flash quickly. When you pair your sensor under Settings
on your device, the light will flash slowly.
Place the end of your bat on a firm surface with the knob
pointing upward. Stretch the round hole in the center of the
sensor strap over the knob. Position the sensor
mount on top of the bat knob. Hold the sensor
mount in place with one hand.
Pull one of the strap ends over a sensor mount
wing, using the top hole in the strap. Pull each
of remaining two strap ends on the respective
sensor mount wing.