- ページ 10

スイッチ HP 11757BのPDF 設置および校正マニュアルをオンラインで閲覧またはダウンロードできます。HP 11757B 42 ページ。 Multipath fading simulator
HP 11757B にも：マニュアル (44 ページ)

Installation and Calibration

Preparation for Use

Warning

tests, notify the nearest Hewlett-Packard oce. If

the shipping container is damaged, or the cushioning

material shows signs of unusual stress, notify the carrier

as well as the Hewlett-Packard oce. Keep the shipping

materials for the carrier's inspection.

To avoid damage to the instrument make sure that the

voltage selection switch on the back of the instrument is

set properly.

This is a Safety Class I product (that is, it is provided

with a protective earth terminal). An uninterruptible safety

earth ground must be provided from the main power

source to the product input wiring terminals through the

power cable or supplied power cable set. Whenever it is

likely that the protection has been impaired, the product

must be made inoperative and be secured against any

unintended operation.

If this instrument is to be energized via an external

autotransformer, make sure the autotransformer's

common terminal is connected to neutral (that is, the

grounded side of the line (Mains) supply.)

Before plugging the Fader into the line (Mains) voltage,

ensure the following steps are taken:

1. Check the line (Mains) voltage to ensure

compatibility with the Fader requirements.

2. Check the line voltage switch on the Fader's rear

panel to ensure proper selection for the line (Mains)

voltage.

HP 11757B