- ページ 14

スイッチ HP 1910-8-PoE+のPDF スタートマニュアルをオンラインで閲覧またはダウンロードできます。HP 1910-8-PoE+ 26 ページ。 1910 switch series
HP 1910-8-PoE+ にも： クイックスペック (43 ページ), データシート (16 ページ), クイックスペック (44 ページ)

ページを印刷する
HP 1910-8-PoE+ スタートマニュアル
CAUTION:
Hold the SFP transceiver module by its two sides when you install or remove the module. Do not touch
•
the golden finger of the module.
Remove the optical fiber, if any, from a transceiver module before installing it.
•
To install an SFP transceiver module and connect the optical fiber:
Wear an ESD-preventive wrist strap and make sure it makes good skin contact and is well
1.
grounded.
Pivot the clasp of the module up. Holding the module, gently push the module into the slot until it
2.
has firm contact with the slot (when the top and bottom spring tabs catch in the slot).
Remove the protection covers from the optical fiber and the transceiver module, and connect the LC
3.
connector of the optical fiber to the transceiver module.
NOTE:
Keep the protection covers for future use.
Figure 19 Installing SFP transceiver module and connecting optical fiber

Connecting the console cable

WARNING!
Do not connect or remove the console cable to or from the PC if the switch has been powered on.
To connect a terminal, for example, a PC, to the switch:
Wear an ESD-preventive wrist strap and make sure it makes good skin contact and is well
1.
grounded.
Plug the DB-9 female connector of the console cable to the serial port of the PC.
2.
Connect the RJ-45 connector to the console port of the switch.
3.
Figure 20 Connecting the console cable
5