- ページ 10

スイッチ HP 3100-16 v2 SIのPDF 設定マニュアルをオンラインで閲覧またはダウンロードできます。HP 3100-16 v2 SI 15 ページ。 Hp 3100 v2 switch series

Configuring IPv6 static routing

Static routes are manually configured. They work well in simple networks. Proper configuration and use

can improve network performance and ensure enough bandwidth for important applications.

Static routes cannot adapt to network topology changes. If a fault or a topological change occurs in the

network, the network administrator has to modify the static routes manually.

The term "router" in this chapter refers to both routers and Layer 3 switches.

Similar to IPv4 static routes, IPv6 static routes work well in simple IPv6 network environments.

Their major difference lies in the destination and next hop addresses. IPv6 static routes use IPv6

addresses, whereas IPv4 static routes use IPv4 addresses.

An IPv6 static route with a destination prefix of ::/0 is a default IPv6 route. The default route is used to

forward packets that match no specific routes in the routing table.

In small IPv6 networks, IPv6 static routes can be used to forward packets. In comparison to dynamic

routes, it helps to save network bandwidth.

Before you configure an IPv6 static route, complete the following tasks:

Configure parameters for the related interfaces.

•

Configure link layer attributes for the related interfaces.

Enable IPv6 packet forwarding.

•

Make sure that the neighboring nodes can reach each other.

•

To configure an IPv6 static route:

Step

Enter system view.

Command

system-view

Remarks

N/A