- ページ 10

スイッチ HP 316095-B21 - StorageWorks Edge Switch 2/24のPDF リリースノートをオンラインで閲覧またはダウンロードできます。HP 316095-B21 - StorageWorks Edge Switch 2/24 18 ページ。 Edge switch release notes
HP 316095-B21 - StorageWorks Edge Switch 2/24 にも： 更新マニュアル (9 ページ), マニュアル (41 ページ), マニュアル (40 ページ), リリースノート (32 ページ), リリースノート (27 ページ), マニュアル (26 ページ), リリースノート (27 ページ), リリースノート (25 ページ), 取付説明書 (24 ページ), リリースノート (23 ページ), リリースノート (23 ページ), リリースノート (22 ページ), リリースノート (23 ページ), リリースノート (19 ページ), リリースノート (19 ページ), 取扱説明書 (17 ページ), リリースノート (17 ページ), アップグレード手順 (16 ページ), 取扱説明書 (16 ページ), 取付説明書 (16 ページ), リリースノート (16 ページ), リリースノート (17 ページ), リリースノート (17 ページ), リリースノート (11 ページ)

ページを印刷する
HP 316095-B21 - StorageWorks Edge Switch 2/24 リリースノート

Firmware installation

This section includes firmware installation information.
Prerequisites for installing and using firmware 09.00.00
Consider the following prerequisites for firmware 09.00.00:
•
If you are using HAFM, firmware 09.00.00 requires HAFM 07.01.00 or later. This minimum
version lets you manage Edge Switches and Directors running 09.00.00 firmware. However, to
use all the new features and enhancements for firmware version 05.xx.xx and later, upgrade
HAFM to 08.09.01, which only runs on the HAFM Appliance (see
•
Check with HP Customer Support for the latest shipping version of HAFM. HAFM should be at the
minimum level before installing the new firmware.
•
If you are using HAFM to upgrade firmware, an Edge Switch 2/24 must be managed with HAFM
08.08.00 or higher before upgrading to firmware 08.xx.xx or later. If you upgrade to firmware
08.xx.xx or later using an HAFM release earlier than 08.08.00, the firmware upgrade may fail.
Firmware 08.01.00 introduced slightly more processor utilization, which can cause the download
to occasionally exceed HAFM's timeout. As an alternative to HAFM, use the switch's HAFM Basic
interface (formerly EWS) to upgrade firmware.
•
Firmware upgrades or downgrades should not be performed using HAFM Basic using Internet
Explorer 5.00.3315.1000x. If this operation is performed, the download operation may not
complete and may eventually time out, leaving the switch with the previous version of firmware.
NOTE:
HAFM is not required for operating hardware products using the firmware.
•
All Edge Switches and Directors in the same fabric should have the same firmware level installed.
Although products can coexist in a fabric running different levels of firmware, all products must
be at the same major functional release level.
Upgrading from an earlier version of firmware
Upgrading to firmware 09.00.00 is nondisruptive to attached devices. The Director or Edge Switch is
not required to be off line before performing an upgrade operation. Limitations to upgrades are clearly
identified if there are any limitations to performing the operation.
Consider the following when upgrading firmware:
•
Before upgrading firmware, HP recommends that you back up the Director or Edge Switch
configuration. See the HP StorageWorks Director Element Manager user guide for more
information. HAFM Basic also provides an option to print or save product configuration to a file.
See the HAFM Basic user guide for more information.
•
All products must be running firmware 08.xx.xx or later before upgrading to 09.00.00. If a
switch is operating with a firmware level earlier than 08.xx.xx, you must upgrade to 08.02.00
before installing 09.00.00
•
Upgrades and downgrades are supported only within a major release, such as 08.xx.xx to
08.xx.xx, or from one major release to the next, such as from 07.01.03 to 08.02.00, or 08.02.00
to 09.00.00. If HAFM Basic is used for upgrades and downgrades, and this rule is not followed,
errors occur and there may be a disruption to attached devices.
10
Table
3).