- ページ 2

スイッチ HP StorageWorks 7110 - Virtual ArrayのPDF 使用方法をオンラインで閲覧またはダウンロードできます。HP StorageWorks 7110 - Virtual Array 4 ページ。 Private loop (hubs/direct connect)
HP StorageWorks 7110 - Virtual Array にも：マニュアルの使用 (34 ページ), アップグレード手順 (12 ページ), マニュアル (4 ページ), マニュアル (4 ページ), インストレーション・インストラクション (2 ページ), マニュアル (2 ページ), マニュアル (1 ページ), マニュアル (1 ページ)

Unpack the deskside assembly and remove the

packing material.

NOTE: The inside of the cover comes with a

structural foam lining. It is part of the cover and

is not to be removed.

Remove the base and end cap from the deskside

assembly.

a. Turn the deskside assembly upside down.

b. Using a Torx T25 driver, remove the 4-screws from

the base and set the screws and the base aside.

c. Using the Torx T25 driver, remove the 2-screws

from the end cap and set the screws and the end cap

aside.

Set the deskside cover on the floor with the long

opening facing up (see cover position in Figure 2).

An empty array with controllers may weigh in excess of 60 pounds. To avoid serious injury,

WARNING!

it is recommended that at least two people lift the array chassis into the deskside cover.

Turn the empty array chassis on its side (Figure 3) in

preparation for inserting into the deskside cover.

Base

End-cap

Figure 2

Figure 3

Cover