- ページ 11

デジタルカメラ Panasonic WV-CP470 SeriesのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Panasonic WV-CP470 Series 13 ページ。 Colour cctv cameras
Panasonic WV-CP470 Series にも：仕様 (2 ページ), 取扱説明書 (13 ページ)

ページを印刷する

1. Move the cursor to BW.

2. Select AUTO1, AUTO2, EXT, ON or OFF using L or M.

AUTO1: The camera selects black and white mode if the picture is dark, or color mode

if the picture is bright enough.

Note: Color picture switches to black-and-white picture and vice versa in approxi-

mately 1 or 2 minutes after detection of illuminance.

AUTO2: Applying AUTO1 may cause malfunction when using a source of near-infrared

light at night because the illuminance changes significantly when switching

between a color picture and a black-and-white picture. This can be prevented by

using the AUTO2 setting to detect the type of light source.

Note: Because the type of light source is detected based on information received

from the CCD image pickup element, an object that is constantly moving or

has the same color as its background may not always be properly recognized.

When choosing the AUTO2 mode, make sure to use a light source having a

wavelength of 800 nm or more.

EXT: Color picture reverts to black-and-white picture when an external day/night

switching signal is received (refer to alarm connections).

ON: Black-and-white mode enabled.

OFF: Color mode enabled.

The factory default setting is OFF.

3. Select AUTO1 or AUTO2 using L or M.

4. Press I.

The AUTO1 or AUTO2 menu appears on

the monitor screen.

5. Move the cursor to LEVEL and select the

illuminance level using L or M.

LOW: Color picture switches to black-and-

white picture at approx.1 lx with F1.4

lens.

HIGH: Color picture switches to black-and-

white picture at approx.5 lx with F1.4 lens.

The factory default setting is HIGH.

6. Move the cursor for DURATION TIME to set the switching time using L or M.

The following switching times are available:

10s--30s--60s--300s

(S)

10-7 BURST (BW)

1. Move the cursor to BURST (BW).

2. Select ON or OFF using L or M.

ON: The burst signal is supplied along with the black-and-white composite video signal.

OFF: The burst signal is not output.

The factory default setting is ON.

Notes:

• We recommend that you usually select ON.

• When the camera is used to synchronize the system for external sync, select

ON to prevent a malfunction.

To reset to the factory settings (CAMERA RESET)

1. Move the cursor to CAMERA RESET. The PUSH SW is highlighted.

2. While holding down L and M, press I for 2 seconds or more. The camera is reset

to the factory settings.

(L)

** BW AUTO1 **

LEVEL

HIGH

DURATION TIME .I..

RET END