- ページ 3

ペイントスプレー Diamond Needle White Diamond CG-750AJのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Diamond Needle White Diamond CG-750AJ 4 ページ。

spray gun.

5. Knurled Adjusting Ring:

The knurled adjusting ring is used for positioning

the front part of gun body. When the push rod is in the right position for the

pump cylinder, the air pressure created by its reciprocating motion will reach

the most appropriate spraying force for cleaning. (Note: The factory settings

are ready for optimal performance). If any adjustment needs to be made,

loosen the two set screws on the front body. Turn the knurled adjusting ring

clockwise or counterclockwise. Tighten the two set screws when the desired

spray condition is achieved. See Fig.6.

After completion of work, unplug from the power source and keep the gun in a

safe place.

Maintenance

To keep the spray gun in good condition and extend its life, please empty the

reservoir container after use. Trigger some shots for a few seconds until all the

liquid in the air cylinder is evacuated. As Fig.7 shows, unscrew the reservoir

container and then pull off the suction base. Put 3-5 drops of light clear oil into

the suction pipe. Trigger on and let the oil be sucked back into the pump

cylinder.

Repair

This spray cleaning gun has been expertly constructed and carefully calibrated.

It has been completely tested before it leaves the factory. Disassembly and

major repairs should be left to professionally trained technicians.

Problems that may occur include: power supply failure, motor failure, nozzle

failure, air cylinder failure, as well as the failure of cylinder spring.

Trouble shooting:

1. Remove from power source before disassembly.