- ページ 8

プールヒーター aquatherm AT800のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。aquatherm AT800 16 ページ。 Swimming pool & spa heat pumps “black cabinet” with analog controls series only
aquatherm AT800 にも：オーナー・オペレーション・マニュアル (12 ページ), インストレーション・マニュアル (8 ページ)

ページを印刷する

Electrical Connections & Wiring

The AT800, AT600 & AT400 re-

quire a MINIMUM of #8 A.W.G.

copper stranded wire, (or

larger if needed.)

You must increase the wire size

under low voltage, high amp

draw, and/or long-run condi-

tions as required by National

Electrical Code.

You must bond the heater ex-

ternally to the pool/spa steel as

required by local codes. A

bonding lug is located on the

bottom front exterior of the unit.

NOTE : See wiring diagrams on

pages 10 & 11

See page 9 for factory specifi-

cation listings also.

This unit is equipped with a

start-up time delay on the

compressor only. Whenever

the unit is started or re-

started, there will be a 5 to 7

minute delay before the

compressor will operate.

for Analog Control Models

DANGER FROM ELECTRICAL SHOCK & ROTATING FAN !

SHUT OFF ALL POWER BEFORE REMOVING ANY PANELS !

CAUTION: MORE THAN ONE DISCONNECTION MAY BE

REQUIRED TO ELIMINATE ALL POWER TO UNIT INCLUD-

ING POWER TO THE OPTIONAL TIME CLOCK OVERRIDE !

BREAKER SIZE RECOMMENDATION

MODEL AT800 & A T600: 50 AMPS

MODEL AT400: 40 AMPS

MINIMUM WIRE SIZE for ALL MODELS

#8 A.W.G. COPPER STRANDED OR LARGER

TRANSFORMER WIRING CHANGE FOR 208 VOLTAGE

NOTE: If the power supply is 208 and not 220 volts, you

must make a simple wiring change to the low voltage

side of the transformer. See diagram on transformer.

WARNING !

3 Phase Compressor Models Are Rotation

Sensitive! Use Refrigerant Gages! Do Not Go By Fan Ro-

tation Since It Will Always Be Single Phase! *SEE PAGE

11 FOR THREE PHASE WIRING DIAGRAM*

Page 8