- ページ 13
電源 Diamond Systems JMM-5312-ADRHのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Diamond Systems JMM-5312-ADRH 18 ページ。 Advanced technology 218w dc/dc power supply pc/104-plus module
ページを印刷する6.3
Output Power Connectors (J9 & J10)
Two screw terminal blocks are used for output power. J9 is a 7-pin block provides +5V and +5V standby output.
J10 is a 5-pin block and provides +12V, +3.3V, and +3.3V standby outputs. Following are the pinouts for the
mentioned connectors.
Connector J9:
Part Number: 1827910
Mating part Number: 1827758
Connector J10:
Part Number: 1827897
Mating part Number: 640621-2
6.4
Remote On/Off Control (J6)
A 2-position latching pin header can be used to connect a remote on/off signal to the power supply. This connector
is located along the right side of the board. An active low signal / contact closure between the input and ground
will turn off all outputs.
Part Number: 640457-2
Mating part Number: 1827732
JMM-5000 User Manual Rev B.01
J9
+5V out
1
+5V out
2
+5V out
3
GND
4
GND
5
GND
6
+5V standby
7
On/Off
GND
www.diamondsystems.com
J10
+3.3V standby
1
+12V out
2
+3.3V out
3
GND
4
GND
5
J6
1
2
Page 13