- ページ 17

プロジェクター Panasonic et-jpc100beのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Panasonic et-jpc100be 28 ページ。

ページを印刷する
Installation (continued)

Connecting the indoor wiring for the power supply

This section describes connecting the indoor wiring for the power supply to the terminal block of the ceiling mount
bracket.
Single copper wires with a diameter of 1.6 mm (1/16ʺ) to 2.0 mm (5/64ʺ) are supported for the wiring.
Single copper wire
Insulation
10 11 mm (13/32" - 7/16")
115 126 mm (4-17/32" - 4-31/32")
Terminal block
Earth terminal
ⅰ
Earth wire
Fixer cable tie attachment position
Power cable
Sheath
Release buttons
Neutral terminal
Live terminal
ⅱ
Power wires
1) Strip the coating off the wires.
 Pull out the indoor wiring for the power supply
(power cable) from the ceiling, strip 115 mm
(4-17/32ʺ) to 126 mm (4-31/32ʺ) of the sheath
off the cable, and then strip 10 mm (13/32ʺ)
to 11 mm (7/16") of the insulation off the two
power wires and earth wire.
 Exceeding the specifi ed dimensions may cause
electric shock.
2) Connect the power cable to the terminal block
of the ceiling mount bracket.
 First, perform proper grounding in accordance
with your country regulations using the earth
terminal of the terminal block. Insert the earth
wire all the way into the earth terminal (
Improper connection may cause a fi re.
 Next, insert the two power wires all the way into
the live terminal (L1) and neutral terminal (N) of
the terminal block (ii). Improper connection may
cause a fi re.
Attention
 Do not connect the power cable of another
projector or lighting via the terminal block of this
product. Doing so may cause a fi re.
Note
 To disconnect the connected power cable from the
terminal block, pull out each wire while pushing in
the corresponding release button on the terminal
block with a fl at-blade screwdriver (with blade edge
width of 6 mm [1/4"] or less and blade tip thickness
of 0.8 mm [1/32"] or less). Disconnect the power
wires fi rst and then disconnect the earth wire last.
3) Fix the power cable to the ceiling mount
bracket.
 Push the power cable connected to the terminal
block back into the ceiling to remove any slack
and then pass the supplied fi xer cable tie
through the fi xer cable tie attachment holes and
use it to secure the power cable to the ceiling
mount bracket.
 Cut off the excess part of the fi xer cable tie so
that the fi xer cable tie will fi t inside when you
attach the projector mount bracket to the ceiling
mount bracket.
) (i).
ENGLISH - 17