- ページ 36

プロジェクター Panasonic PLC-XP40のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Panasonic PLC-XP40 44 ページ。 Multimedia projector

ページを印刷する

SETTING

Power management

This function turns Projection Lamp off when this projector detects

signal interruption and is not used for a certain period in order to

reduce power consumption and maintain Lamp-life. (This projector is

shipped with this function ON.)

Power Management function operates to turn Projection Lamp off

when input signal is interrupted and any button is not pressed over 5

minutes. This function operates as follows;

1. When any input signal is interrupted, "No signal" and counting

down display appears (for 5 minutes).

2. After counting down for 5 minutes, projector lamp and READY

indicator are turned off.

3. When READY indicator flashing, Projection Lamp can be

turned on again (Power Management mode).

In this Power Management mode, Projection Lamp is

automatically turned on when input signal connected or

projector is operated with any button on Top Control or on

Remote Control Unit again.

On start

When this function is "On," projector is automatically turned on just

by connecting AC Power cord to a wall outlet.

Note ; Be sure to turn projector off properly (refer to section

"TURNING OFF PROJECTOR" on P19). If projector is turned

off in wrong steps, On Start function does not operate

properly.

Remote control

This projector has two different remote control codes; factory-set

normal code (Code 1) and secondary code (Code 2). This switching

function prevents remote control operation mixture (jam) when

operating several projectors or video equipment together.

When operating projector in "Code 2," both projector and Remote

Control Unit must be switched to "Code 2."

To change code of Projector;

Set Remote control in SETTING MENU to "Code 2."

To change code of Remote Control Unit;

Press both MENU and IMAGE buttons on Remote Control Unit

together for over 10 seconds.

After changing code, make sure Remote Control operates properly.

To return to normal code (Code 1), operate both projector and

Remote Control in ways above again.

NOTE : When batteries of Remote Control Unit are replaced or ALL-

OFF switch is turned to "ALL-OFF," remote transmit code

automatically returns to normal code (Code 1).

Lamp counter reset

This function is used to reset Lamp Replace Counter. When

replacing Projection Lamp, reset Lamp Replace Counter by using

this function. Refer to page 39 for operation.

Time left until Lamp off.

Press SELECT button at this icon to

display other items.

On start

Press SELECT button at this icon to

display previous items.

Move pointer to item and then press

POINT LEFT/RIGHT button(s).

Move pointer to Lamp counter reset and then press

SELECT button. Message "Lamp replace counter

reset?" is displayed.