- ページ 42

プロジェクター Panasonic PT-AE4000UのPDF 機能説明をオンラインで閲覧またはダウンロードできます。Panasonic PT-AE4000U 50 ページ。 Full high-definition home cinema projector
Panasonic PT-AE4000U にも：取扱説明書 (36 ページ), パンフレット＆スペック (6 ページ)

ページを印刷する

Appendix

Technical Information

Serial terminal

The serial connector which is on the connector panel of the projector conforms to the RS-232C interface

specification, so that the projector can be controlled by a personal computer which is connected to this connecter.

J Connection

J Pin assignments and signal names

J Communication settings

Signal level

Sync. method

Baud rate

Parity

J Basic format

STX

Command

Start byte

(02h)

The projector can not receive any command for 10 seconds after the lamp is switched on. Wait 10 seconds

before sending the command.

If sending multiple commands, check that a response has been received from the projector for one

command before sending the next command.

When a command which does not require parameters to be sent, the colon (:) is not required.

If an incorrect command is sent from the personal computer, the ER401 command will be sent from the

projector to the personal computer.

42 -

NGLISH

Pin No.

RS-232C

Asynchronous

9 600 bps

None

Parameter

1 bytes

3 bytes

1 byte -

4 bytes

D-sub 9 pin (male)

Serial terminal (female)

Signal name

TXD

RXD

GND

RTS

CTS

Character length

Stop bit

X parameter

S parameter

ETX

The data streaming from the computer will

start with STX, and proceed to Command,

Parameter and end with ETX. You can add

End

the required parameter.

(03h)

Computer

Contents

Transmitted data

Received data

Earth

Connected internally

8 bits

1 bit

None