- ページ 19
プロジェクター Panasonic PT-D6000EのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Panasonic PT-D6000E 42 ページ。 Dlp based projector commercial use
ページを印刷する
Projecting
Projecting a image
Switching on the projector
When using an optional lens, install a projection lens
before switch on the projector.
1. Connect the supplied mains lead (220 - 240 V AC,
50 Hz/60 Hz) to the AC IN terminal.
2. Remove the projection lens cover from the lens.
3. Switch the POWER switch on that is on the side of the
projector.
The power indicator lamp on the projector will flash in red.
After a short period, the indicator will illuminate and the
projector will enter standby mode.
POWER switch
4. Press the POWER ON button
The power indicator lamp illuminates in green and soon the
image is projected on the screen.
.
NOTE:
• If the projector is powered up at about
up period of approximately 5 minutes may be necessary to
start projection. The temperature monitor (TEMP) lamp lights
up during the warm-up period. When the warm-up is
completed, the temperature monitor (TEMP) lamp turns off
and the image is projected on the screen.
• If the temperature of the operating environment is low and
warm-up takes more than 5 minutes, the projector will judge
that a problem has occurred and the power will be turned off
automatically. If this happens, increase the temperature
around the projector so that it is
then turn on the POWER switch and press the POWER ON
button again.
AC IN terminal
POWER ON button
0 °C (32 °F)
, a warm-
0 °C (32 °F)
or higher, and
Making adjustment and selection
It is recommended that the projector be allowed to warm
up for at least 30 minutes before any adjustments are
made to the focus.
1. Roughly adjust the focus of the lens.
2. Select and set the projection scheme of
INSTALLATION and COOLING CONDITION settings in
PROJECTOR SETUP menu.
3. Select the input signal by pressing the INPUT SELECT
buttons.
4. Adjust the vertical tilt of the projector with the front leg
adjusters.
5. Adjust the shift position of the projection.
If the input signal is RGB signal, additionally press the
AUTO SETUP button to adjust the position of the image.
6. Zoom the lens so the image fills the screen.
7. Readjust the focus.
8. Readjust the zoom so that the image size fits in the
screen.
Adjusting focus, zoom and shift
Pressing the LENS button changes the
Control buttons of the
setup screen in order of FOCUS, ZOOM
projector
and SHIFT. Press F G I H to adjust.
Press FOCUS, ZOOM or SHIFT button
to display the setup screen. Press F G
Remote control buttons
I H to adjust.
INPUT SELECT buttons
CAUTION:
• Be careful not to catch your fingers between the lens and
shroud when shifting the lens.
NOTE:
• The setup screen will be displayed with the optional fixed lens
though, it will not be functioning.
• Pressing F G I or H for 3 seconds or more, performance
the adjustment faster.
LENS button
E
NGLISH - 19