- ページ 6

ソウ Diamond Tech International Diamond Laser 7000 Band SawのPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Diamond Tech International Diamond Laser 7000 Band Saw 6 ページ。 Band saw

ページを印刷する
Problem:
Work material becomes jammed.
Cause:
Twisted blade: Caused by work material being forced.
Solution:
Before freeing any jammed material:
1. Turn off power switch.
2. Open front panels of the saw.
• Rotate top wheel assembly counter clockwise until blade is freed from work material.
• Hold Blade firmly against Blade Guide Assembly to prevent the Blade from being pulled
or stretched while you are disengaging you material.
• Maneuver work material around the blade until free.
Problem:
Blade twists, poor cutting accuracy
Cause:
Blade tension too loose (see "Adjusting Blade Tension" page ) or worn Blade Guides
Solution:
1. Adjust Side Guides on both Upper and Lower Blade Guide Assemblies as close as
possible to the sides of the Blade, being careful not to pinch the Blade.
2. Change Blade guides if necessary.
3. Push material against Blade at a slower rate.
Tips on Using Your Laser Band Saw
• Do not force material into the Blade. Allow the work to glide smoothly. Avoid twisting the blade
on tight curves.
• Use a waterproof pen to mark your pattern on the material.
• Glass cutting sludge may set up hard, so avoid putting sludge down plumbing drains.
• To back out of a cut, turn saw off and slowly ease the material away from the blade.
• Two or more pieces may be cut at the same time by "stacking" them together using "tacky wax" or
double-sided tape.
• Clean thoroughly and loosen blade tension when saw is not in use for extended periods.
DIAMOND TECH INTERNATIONAL, USA
Diamond Laser 7000 One Year Warranty
All DIAMOND TECH INTERNATIONAL machines and accessories are manufactured to high quality standards and
are inspected by highly qualified technicians. To obtain additional information regarding your quality product or to obtain
parts, service, or warranty assistance, please call our toll-free number (800) 937-9593, send a fax to (813) 806-1988 or
The DIAMOND LASER 7000 is warranted to the original purchaser for one full year from the original purchase date. During
the one year period, a defective DL7000 ™ will be repaired or replaced when the machine is returned, prepaid to DIAMOND
TECH INTERNATIONAL . If the DL7000 ™ suffers damage due to customer modifications and/or is used for any application
other than that for which it was designed this warranty is void. The DL7000 ™ is warranted against defective materials or
workmanship. This warranty does not include damage due to: a) neglect; b) accident; c) unreasonable use; d) improper
maintenance; e) or any other cause not attributed to defects in material or workmanship. This warranty specifically
excludes the Diamond Laser Steel Blade and Blade Guide Sets.
Trouble Shooting Guide
Manager Of Technical Services
5600-C Airport Blvd., Tampa, Florida 33634
HELP LINE 800-937-9593 (inside the U.S.)
813-806-2923 or FAX: 813-806-1988