- ページ 7

ソウ Diamond Tech International Power Miter IIのPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Diamond Tech International Power Miter II 9 ページ。 Chop saw

Workpiece Support

Long pieces need extra supports. The supports should be placed along the workpiece so the

workpiece does not sag and your hand holding the workpiece is positioned 4" or more from the

blade path. The support should let the workpiecelieflat on the base and work table during the

cutting operation.

Lubrication

Lubricate blade drive shaft (2 lube ports) with machine oil

before each use.

Removing and Installing Blade

WARNING: To reduce the risk of injury from a thrown workpiece or thrown pieces of blade, do not use

a blade larger or smaller than 4" diameter.

WARNING: To reduce the risk of injury from unexpected starting, unplug the saw whenever you are

removing or installing the blade.

1. Unplug the saw from the outlet.

2. Remove blade cover.

3. Using two adjustable wrenches, secure the Hex Nut located behind the blade with one wrench,

then loosen the Blade Retaining Nut by turning clockwise. Remove front Blade Support Washer,

then carefully remove Blade.

4. Securely install new blade with teeth pointing down. Then replace Blade Support Washer.

WARNING: Always use both Blade Support Washers to maintain stability and safety of the Blade

NOTE: Use only Power Miter II™ blades designed for use with your Power

Miter II™ Saw. After installing new blade, make sure that the blade clears the Miter/Angle Guide

Slot at the 0° and 45° positions.

5. WARNING: Never use saw without Blade Cover securely in place.

Make sure that the Blade is seated properly on the Arbor. Replace blade retainment nut and

tighten securely by turning Blade Retaining Nut counterclockwise.

6. Replace and tighten Blade Cover securely.

Blade Washer

Blade

Blade Retaining Nut

Basic Saw Operations

Lubricating Ports

Blade

Blade Washer

Blade Cover

Blade Retaining Nut