- ページ 2

自動車アクセサリー Diamondback CVR-180.5のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Diamondback CVR-180.5 2 ページ。 Heavy duty truck bed cover for 2016–up nissan titans

ページを印刷する

ADJUST THE LOCK RODS

Use an 1/8" hex key to loosen the

set screws on the linkages of the

driver-side lock rods.

Adjust the length of the lock rods and retighten the set screws so that:

A. with the lock handle in the open position, the rod tips clear the

angle iron (forward) and the T-panel gutter (rearward),

B. with the handle in the closed position, the forward rod tip does

not strike the bulkhead, and

C. the rods point downward.

ATTACH THE GAS SPRINGS

Attach the gas springs to the ball studs.

To avoid premature failure of your gas

springs, attach them barrel up, shaft down.

Leave the cover closed and locked

for 24 hours to allow the weather-

strip adhesive, which is pres-

sure-sensitive, to fully cure.

WWW.DIAMONDBACKCOVERS.COM

1/8 " Hex Key

Position the lock rods tight

against the underside of the

angle iron (forward) and T-panel

gutter (rearward) so that they

draw the panels down and

compress the perimeter

weatherstrip. Tighten

the rod guide

brackets with a

7/16" socket.

Repeat steps 8–10 for the passenger-side lock rods.

Double-check both panels to ensure they open, close, lock and seal

correctly. If at any point the weatherstrip does not touch the bed rails,

readjust the lock rods and mounting brackets as needed.

To ensure the best weatherstrip adhesion, leave your

cover and tailgate closed for 24 hours after you've

made your final adjustments.

Operating the access panels is easiest when

you press down as you open or close them.

7/16" socket

MARCH 2016