- ページ 14

IPカメラ easynet EC-2M-F1N-ONVのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。easynet EC-2M-F1N-ONV 20 ページ。

2. Installation and Configuration

2.5 Resetting to the Factory Default Settings

To reset the Network Camera to the original factory settings, use the Reset button on the

network camera, as described below:

Using the Reset Button

Follow the instructions below to reset the HD Camera to the factory default settings using the

Reset button.

1. Power off the HD Camera by disconnecting the power adapter or Cat5e/Cat6 network

cable if it is connected to Power over Ethernet.

2. Remove the rear cap of the camera.

3. Press and hold the Reset button with a straightened paperclip while reconnecting the

power.

4. Keep the Reset button pressed during about 2 seconds.

5. Release the Reset button.

6. The HD Camera resets to factory defaults and restarts after completing the factory

reset.

7. Close the rear cap of the camera.

CAUTION: When performing a Factory Reset, you will lose any settings you have saved.

Please consult with NUVICO Technical Support first before doing so since this can

interrupt the communication to the recorder.