- ページ 9

ステレオ・イコライザー DiBiQuadro GeminiPTEのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。DiBiQuadro GeminiPTE 11 ページ。

UpFilterTransBand.
UpSampling Filter Transition Band, in
percent of the spectral space of the
input signal between filter's -3 dB point
and the Nyquist frequency.
UpFilterType. It defines the UpSampling
filter's phase response: Minimum Phase
or Linear Phase.
DownFilterTransBand.
DownSampling Filter Transition Band, in
percent of the spectral space of the
output signal between filter's -3 dB
point and the Nyquist frequency. If you
are working at sample rates higher
than 44100/48000Hz, we suggest to
increase it to 43% to have a smoother
low pass filter and to reduce the
latency without impacting the audible
frequencies.
DownFilterType.
It
DownSampling filter's phase response:
Minimum Phase or Linear Phase.
PreRenderFactor. Together with input
SampleRate
and
PreRenderFactor affects how many
samples will be pre-rendered by the
model before the real processing. We
suggest to set it to the highest value –
32x – in Offline mode.
DONE. It closes the SET window.
This
is
the
This
is
the
defines
the
UpSamplingFactor,

TWEAK

TWEAK window
The TWEAK window gives you the
power
to
modify
component of the circuit. Even the
Triode model of the 6DJ8/ECC88 can
be tweaked in the NonLinearSolver tab.
Play with this window very carefully,
possibly in front of an analyzer, to get
exactly what you are looking for. We
do not guarantee that any possible
combination of values makes sense, so
it's up to you to find a configuration
that works and satisfies your needs.
RESET. It restores the default values for
all configurations in the TWEAK window.
9
every
single