- ページ 2

池のポンプ EasyPro Eco-Clear EPS4900のPDF 取扱説明書、安全性、保証についてをオンラインで閲覧またはダウンロードできます。EasyPro Eco-Clear EPS4900 8 ページ。 Submersible pond pump

ページを印刷する

10.

All electrical work must be performed by a qualified technician. Always follow the

National Electrical Code (NEC) or the Canadian Electrical Code as well as all local,

state and provincial codes. Code questions should be directed to your local electrical

inspector. Failure to follow electrical codes and OSHA safety standards may result

in personal injury or equipment damage. Failure to follow manufacturer's installation

instructions may result in electrical shock, fire hazard, personal injury or death, damaged

equipment, provide unsatisfactory performance and may void manufacturer's warranty.

11.

Do not carry or lift the pump by the power cord.

12.

Never use an extension cord or tamper with power cord. Power cord should not become

bent, twisted, abraded or cut. A damaged cable may cause electric leakage, shock or

fire. The power cord cannot be replaced, and unit should be replaced if cord becomes

damaged.

13.

Do not remove the pre-filter housing during operation of the pump.

Features

• Permanent magnet motor for high efficiency and long life.

• Oil-less design is safe for fish and plants

• Impeller designed for passing debris up to 3/8" diameter

• Adjustable direction outlet for use with 1", 1 1/4" or 1 1/2" kink free or 1 1/2" PVC tubing

• Ceramic impeller provides high wear resistance and long life

• Epoxy sealed motor is waterproof, safe and reliable

• Pump can be run continuously 24 hours per day.

Assembly and General Installation

1. The pump can be placed at the bottom of the pond. One end of the hose will connect to the

pump outlet and the other will feed a filter or waterfall device.

2. Maximum performance is achieved when used with largest outlets and tubing sizes available.

Restricting water flow with small accessories will reduce the performance of the pump.

3. Select the step barb fitting or the PVC adaptor fitting based on type of tubing being used.

4. When using the step barb fitting, use a hacksaw to remove

any smaller steps than the tubing being used.

5. Secure the adjustable ball joint fitting to the pump outlet

and attach the appropriate tubing adapter by hand

tightening the locking nuts.

6. Secure tubing to adapters. Use clamps (not included)

on barb fittings or rubber coupler (not included) for PVC

adaptor fitting.

7. When moving the pump be sure to lift only by handle and

not by power cable.

8. Place the pump on a flat brick or stone on the pond bottom. This keeps the pump out of the

sludge and prevents excess debris from entering the pump.

Cut here for

1 1/4" tubing

Cut here for

1 1/2" tubing

Step 4