ページを印刷するMachine description
3
Machine description
3.1
General machine description
The machine is constructed from a number of main components, see Figure 3-1, page
9
and Figure 3-2, page 10. For each machine model in the series, there are a
number of different motor alternatives, see tables in Technical data, page 28.
The machine is based on a wheeled chassis. The motor with the rotating grinding unit is
mounted on the lower part of the chassis enabling some movement between the chassis
and the motor assembly.
The machine is equipped with a lifting eye on the chassis and two lifting handles on the
grinding head, see Figure 3-1, page 9. The lifting eye is intended for lifting the
complete machine. The lifting handles are intended for lifting the grinding head, when it
is separated from the chassis, and then only for short, low lifts, e.g. into the boot of a
car. The lifting handles are not to be used for lifting the complete machine.
The handle can be placed in a number of different working positions by loosening the
locking mechanism for adjusting the handle (see Figure 3-2, page 10) and moving the
handle up and down to the desired working height. The angle of the handle (see
Figure 3-2, page 10) can also be adjusted to obtain the best ergonomics. The handle
can also be placed in the upright position, which must be used when the machine is
tipped to enable access under the grinding head, e.g. when changing tools.
The machine has a connection for an external suction hose, which is used during dry
grinding.
The machine can be easily equipped with a large number of tools, depending on the
material to be ground. For the different tools, see HTC's Product Catalogue under the
Grinding Guide tab.
8
HTC GL 270 HD
2.0