- ページ 3
池のポンプ EasyPro Spirit TLS2750のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。EasyPro Spirit TLS2750 6 ページ。 Pond & stream pump
Installation
•
Do not paint casing, over heating may occur
•
Lift only by handle, not by power cable or float switch
•
Do not hang pump in water, install on solid flat base in upright or
horizontal position
•
Install proper outlet adapter for pipe or hose
•
Make sure that power cable plug and power outlet are away from
water and water discharge pipe/hose.
Operation
1.
Do not start operation with people standing near intake or
outlet.
2.
Do not operate out of water.
3.
Pump must remain fully submersed.
4.
Only use pump for circulation, transfer or removal of water with limit-
ed solids
1
5.
Do not pump oil, salt water, sewage, food or chemical liquids.
6.
Do not allow dry operation
7.
Do not allow foreign objects to clog or enter intake
8. In case of power outage, turn off power switch to avoid damage when
power is restarted.
9. If excessive vibration occurs turn off power immediately.
Service & Maintenance
1.
Disconnect all power supplies before inspection or service to
avoid possible electrical shock.
2.
The pump should be removed from the pond on a regular basis,
cleaned and checked over for damage to prolong the life of the pump.
3. Clean the impeller and intake screen when the flow is visibly reduced.
4.
Clean the pump and impeller with clean fresh water.
5.
Check inside the impeller housing for large debris or algae, which
could reduce the flow.
6.
Check and tighten nuts and bolts if required, refer to dealer for advice
on other repairs.
7.
Winterization/Storage: When the pump is out of use for extended time
- wash and dry it then store indoors in a non-freezing location. It is
best to store in a bucket with about an 8" water depth. It is essential
to prevent any risk of the pump freezing.
8.
If the pump is left in water but not operating regularly, test run it at
least once a week.
/
" or smaller.
4