- ページ 7
室内装飾品 DIBSIES MODERN EXPRESSIONS TOY BOXのPDF 組立マニュアルをオンラインで閲覧またはダウンロードできます。DIBSIES MODERN EXPRESSIONS TOY BOX 10 ページ。
ページを印刷する
INSTRUCTIONS
Step 5 - Attaching the Part 6 Panel
1.
Locate the Part C
Dowels
Begin Step Five by locating the upper
section of the Part 7 assembly where
there are three mid-section holes. Locate
three Part C dowels and align the dowels
into place.
Step 6 - Attaching the Side Panel
1.
Locate and align the
Part H barrel nuts
Begin Step Six by locating six Part H
barrel nuts and aligning them to the
following locations, as shown. Push
the barrel nuts into place and ensure
the barrel nuts are snug.
4.
Locate and align the
Part G bolts
Locate six Part G bolts and align them
to the holes shown. Push the bolts
into place, and secure the bolts using
a Phillips screwdriver. Take care not
to over tighten the bolts.
7
2.
Secure the Part C Dowels
Secure the Part C dowels into place.
2.
Locate and align the
Part C dowels
Next, locate five Part C dowels
and align them to the following
locations shown. Push the
dowels into place.
3.
Locate Part 6 and align
into place
Next, locate Part 6 and align it to the
previously installed Part C dowels. Slowly
push Part 6 into place and ensure it is
pushed all the way down.
3.
Locate and align Part
4 to the assembly
Locate Part 4 and align it to the
assembly. Slowly push Part 4 into
place. Make sure that the holes of
the Part 4 panel match that to the
portruding Part C dowels.
5.
Locate the Part 1
assembly and align
Finally, locate the Part 1 assembly
from Step 1 and align it so that
the lower edge with the portruding
hardware of Part 1 aligns with the
upper corner hole of Part 4, as shown.
Push the assembly into place.