- ページ 6
湿らせる Bionaire BU1400のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Bionaire BU1400 8 ページ。 Ultrasonic humidifier
ページを印刷する
• Mineral deposits should be soaked for up
to 20 minutes in plain vinegar and water to
help with their removal.
• DO NOT clean any part of your humidifier in
the dishwasher.
Daily maintenance:
1. Before cleaning, switch off the unit and unplug
the unit from the electrical outlet.
2. Lift and remove the tank of the humidifier.
3. Drain and rinse the base and tank thoroughly
to remove any sediment or dirt. Wipe clean
and dry with a clean cloth or paper towel.
4. Refill the tanks as instructed in "Operating
Instructions". Do not over fill.
5. If moisture forms on walls or windows in your
home, turn the humidifier off.
6. Wipe out and clean excess oil and other
residues from reservoir.
STORAGE TIPS
If you do not plan to use your unit for an
extended period of time, it is important that you
follow these instructions to help prevent
stagnation of water in the unit.
1. Turn the unit off and disconnect from the
outlet. Remove the water tanks, then empty
the tanks and the base completely. Clean the
humidifier as instructed in the cleaning
instruction section.
2. Dry the unit thoroughly. DO NOT leave any
water in the unit when storing.
3. Pack the humidifier in its original carton and
store in a cool, dry place.
SERVICE INSTRUCTIONS
1. DO NOT attempt to repair or adjust any
electrical or mechanical functions on this unit.
Doing so will void the warranty.
The insides of the unit contain no user
serviceable parts. Only qualified personnel
should perform all servicing.
2. Should the unit stop working, first check the
fuse in the plug (UK only) or fuse/circuit
breaker at the distribution board is operating,
before contacting the manufacturer or service
agent.
3. If you need to exchange the unit, please
return it in its original carton, with a sales
receipt, to the store where you purchased it.
4. Should your humidifier require service, please
contact your local dealer.
FOR U.K. AND IRELAND ONLY
If the plug is not suitable for the socket outlets in
your home, it can be removed and replaced by a
plug of the correct type. Please refer to
"Installation of a plug" below.
Installation of a plug applicable to
U.K. and Ireland
NOTE: If the terminals in the plug are not
marked or if you are unsure or in doubt about
the installation of the plug please contact a
qualified electrician.
If a 13A 3-pin plug is fitted, it must be an ASTA
approved plug, conforming to BS1363 standard.
Replacement 3A fuses must be BSI or
ASTABS1362 approved.
This product is fitted with a 13A plug complying
to BS1363. If this plug is unsuitable or needs to
be replaced, please note the following: The wires
in the mains lead are coloured as such:
BROWN - LIVE
BLUE - NEUTRAL
Please note that the colour of these mains wires
may not correspond with the colour markings
that identify the terminals in your plug. Please
proceed as follows:
The BROWN coloured wire must be connected
to the terminal, which is marked with the letter
"L" or is coloured RED.
The BLUE coloured wire must be connected to
the terminal, which is marked with the letter "N"
or is coloured BLACK.
DO NOT CONNECT either of these wires to the
earth terminal in the plug. The earth terminal
plug is marked with the letter "E", or with the
earth symbol
, or coloured GREEN, or
GREEN and YELLOW.
GUARANTEE
Please keep your receipt, as this will be required
for any claims under this guarantee.
This appliance is guaranteed for 2 years after
your purchase as described in this document.
During this guaranteed period, if in the unlikely
event the appliance no longer functions due to a
design or manufacturing fault, please take it
5