- ページ 5

照明器具 EasyPro AquaShine WFL2-200のPDF 取扱説明書、安全性、保証についてをオンラインで閲覧またはダウンロードできます。EasyPro AquaShine WFL2-200 8 ページ。 Fountain light kit, stainless steel, warm white led light kits, two-light kits for fountains up to 3/4 hp/three-light kits for fountains up to 2 hp, compatible with fountains and aquafloats and kasco vfx or jf series fountains with one piece float

ページを印刷する

LED Three Light Kit Assembly Instructions

for 2 hp Kasco VFX, AF and JF Series Units

Actual light fixture may vary slightly from fixtures below.

1. For 2 hp Kasco units use the 3/4" pan head

screws from hardware pack labelled LKH-KBW

with nylock nut and smaller washer. Put screw

through the bottom of the bracket supplied with

the Kasco float. Then line it up in hole on light

bracket and secure with washer and nylock nut

as shown in Figure 1. Attach to brackets on 2 hp

Kasco in three locations seen in Figure 2.

2. Connect pigtails to three way cord splitter (three

x 1). To do this, be sure the pigtails go around the

motor screen in an orderly way so all lights can

be connected without twisting. When connecting

cords, be sure the o-ring is present in the female

portion of the connectors. (Figure 3) Push pigtails

into splitter and secure with 1/2 turn quick

connect nut on splitter. (Figure 4)

3. Connect main cord to the remaining end of the

splitter section. Be sure the o-ring is present

(Figure 3) and secure cords with 1/2 turn quick

connect nut (Figure 4). Multiple cords can be

connected up to 300' long between the light

fixtures and the control unit.

4. The main cord MUST BE SECURED to the float

of the fountain. Use plastic cable ties included in

your kit to do this. This acts as a strain relief for

the cords.

5. Adjust the angle of the light fixtures based on the

spray pattern being used. Tip in toward center

for narrower pattern and tip out slightly for wider

pattern.

6. Plug the main cable into the pigtail of the mounted

controller unit. Be sure to mount the weatherproof

controller with timer in a secure location near a

power supply and plug into 115 volt outlet.

See "Setting the Timer" for detailed instructions

on the controller.

7. Over time the LED lights may appear dimmer than when new. This is caused

by algae or sediment on light lens. This can easily be removed with a small

brush (a toothbrush works great).

Figure 1

Figure 2

o-ring

Figure 3

Figure 4