- ページ 5

エアクリーナー Bionaire BAP1200T-CNのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Bionaire BAP1200T-CN 8 ページ。 With aer1 total air filters

ページを印刷する

C L E A N I N G A N D M A I N T E N A N C E

CLEANING AND MAINTENANCE

Cleaning the unit:

1. Turn off and unplug the air cleaner.

2. The outside of the unit can be cleaned with a soft,

clean dampened cloth.

3. The air inlet grill (see figure 1) can be cleaned with a

soft, clean damp cloth.

4. The filtered air outlet can be cleaned of dust with a

small soft brush.

5. If you wish to clean the inside of the air purifier,

please only use a dry, soft cloth to wipe it down. DO

NOT WASH the Aer1

washed by using a mild dish soap and water. Rinse

thoroughly. Allow to air dry completely prior to

reinstalling into the Air Inlet Grill (D).

6. NEVER use detergents, gasoline, glass cleaner,

furniture polish, paint thinner or other household

solvents to clean any part of the air cleaner.

WARNING: Do not allow moisture to come in contact

with the main housing of the air cleaner.

FILTER REPLACEMENT INSTRUCTIONS

Every few weeks, check the condition of filters. Filter life

will vary, depending on air quality and usage (see

below). Under normal conditions of continuous use, the

Aer1

Total Air and Odor Filter will last 4 months while

the Allergen and Germ Filter will last 12 months.

After approximately 4 months of operation, it is

recommended to service the filters:

• Filters with a 4-month filter life: Perform

maintenance to wipe your unit clean, wash the foam

pre-filter and to replace the Aer1™ filters.

• Filters with a 12 month filter life: Perform annual

maintenance to wipe your unit clean, wash the foam

pre-filter and to replace the Aer1™ filters.

filters. The Pre-filter (E) can be

To replace your filter:

1. Turn off and unplug the air cleaner before attempting

to replace the filters.

2. Remove each of the filters from the unit by pulling

them gently towards you.

3. Discard the Aer1

filters. DO NOT attempt to clean them.

4. Remove protective plastic bags and install new Aer1

filters into the unit.

NOTE: A hang tab and filter clips ensure the filter

attaches properly.

1. Make sure the hang tab

is securely in place. Align

the clip on the top of the

filter with the rails on the

inside of the unit. Gently

slide the filter onto the

rail (see Figures 2 and

3).

2. Place washable foam pre-

filter and air inlet grill

back onto unit securely.

Figure 2

Figure 3