- ページ 4
電気ヒーター Bionaire BCH9208のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Bionaire BCH9208 10 ページ。 Bionaire electric heater user manual
Bionaire BCH9208 にも： 取扱説明書 (2 ページ), 取扱説明書 (2 ページ)
ページを印刷する
F e AT u R e S - O P e R AT I O N S
battery Replacement
1. Locate the battery compartment on the back of the
remote control handset. Insert a small object (such as
a pin or paper clip) into the hole of the battery cover
lock (see Figure 3) and slide out the battery cover.
Figure 3
B
A. Battery Cover Lock
B. Battery cover
2. Remove old battery.
3. Place new battery into battery compartment.
4. Slide battery compartment into the remote control
handset until the Battery Cover Lock is securely latched.
5. For your convenience, a remote control holder is
integrated into the back of the heater housing.
NOTeS:
• THIS PRODUCT CONTAINS A BUTTON BATTERY. IF
SWALLOWED, IT COULD CAUSE SEVERE INJURY IN JUST 2
HOURS. SEEK MEDICAL ATTENTION IMMEDIATELY.
• Remove the battery from the equipment when it is not
being used for an extended period of time.
• Remove the used battery promptly.
• Do not discard used batteries into household trash
containers. Contact your local government for disposal or
recycling practices in your area.
A
Insert pin here
FCC STATeMeNT
Potential for Radio/Television interference
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired
operation.
This product has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15
of the FCC rules.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
The product generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that the interference will not occur in a
particular installation. If the product does cause harmful
interference to radio or television reception, which can be
determined by turning the product on or off, the user is
encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the product and the
receiver.
• Connect the product into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
• Changes or modifications not expressly approved by
the party responsible for compliance could void the
user's authority to operate the equipment.