カメラアクセサリー Easyrig STABIL G2のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Easyrig STABIL G2 2 ページ。
ページを印刷する
1
2
3
Design protection USA / EU / INDIA: DM/203947 & 79612
Trademark USA / EU / INDIA / CHINA: Pending
Easyrig STABIL G2
Setup
Lift the loose end of the STABIL upwards
until it self-locks into position. Keep hands
clear of the connection joint to avoid injury.
Compacting the arm for transport:
1. Set the Vario 5 power pack to the lowest
tension for easier disassembly.
2. Hold the base of the STABIL with one
hand and pull the end of the arm
outwards.
3. Fold the arm against the base of the
STABIL and then fold the whole arm
into the vest.
Adjusting the tension on the Vario 5
If you have a Vario 5, adjust the power
pack to match your camera setup.
While adjusting the tension of the power
pack make sure to lock the arm or
hold it at the lowest position to avoid
interference from the STABIL.
For further details please read the Vario
5 user manual.
Adjusting the tension on the STABIL
Increase the tension of the spring by turning
the knob clockwise. The knob will make a
clicking sound to indicate your new setting.
Decrease the tension by turning the knob
counter-clockwise. The Easyrig STABIL can
take weights between 5-25 kg (11-55 lbs).
The Easyrig STABIL is adjusted correctly if
the arm is resting between the lowest and
highest position.
Note that the operational weight will be
limited to the powerpack / lower arm.
Turn page