- ページ 6

医療機器 Bioness Vector baseのPDF クリニシャンズ・マニュアルをオンラインで閲覧またはダウンロードできます。Bioness Vector base 18 ページ。

Mechanical Track

The Mechanical Track is mounted overhead, typically attached to a support beam, floor or truss, and

the trolley runs on the track. The Mechanical Track defines the horizontal aspect of the walking path

of the patient. The track can have one or more trolleys on it. The track includes straight or curved

portions that form either an open track configuration or a closed loop track configuration.

An open track configuration utilizes two End of Track Bumpers on both ends of the track. These

bumpers are designed to ensure that the trolley is safely stopped at the end of the track.

Vector Base Trolley

The Vector Base Trolley is attached to and moves along the overhead Mechanical Track. The trolley has

an integrated spring that allows the patient when using the system to experience a more natural gait.

Trolley Rope

The trolley rope attaches the trolley to the Spreader Bar. The trolley rope material is a 10mm diameter

HMPE (High Modulus Polyethylene) and after installation is at a fixed length.

Spreader Bar

The Spreader Bar has two rope pulleys with rope attached to carabiners, which attach to a Patient

Harness at two points. On each side of the Spreader Bar there are three holes built to accommodate

patients of different widths.

Patient Harness

The Patient Harness secures a patient during a therapy session. The Patient Harness comes in a

variety of different sizes and attaches to the Spreader Bar.

Be sure to review this guide, including all safety information, before using the Vector Base System. If

you have questions contact Bioness at (800) 211-9136, Option 3 (in the United States) or your local

distributor (outside of the United States). You can also visit the Bioness website at: www.bioness.com.

Caution: Do not use the Vector Base System until you have been properly trained by a Bioness

representative.

Clinician's Guide