- ページ 2
計測機器 Dickey-John INSTALAB 700のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Dickey-John INSTALAB 700 8 ページ。
ページを印刷するINSTALAB 700 QUICK START GUIDE
INSTALLATION
Inspect the unit for damage that may have occurred during shipping. If damage is found, immediately file a claim with the carrier
and notify your DICKEY-john sales representative and return unit in original packing materials.
IMPORTANT:
The Instalab and printer (optional) must not be used in hazardous (classified) locations as defined in
Article 500 of the NFPA Handbook of the National Electrical Code.
1. The Instalab should be placed on a level surface and in a location where it is protected from rapid changes in ambient
temperature.
2. Connect the power cord to a 3-wire (grounded) 120 VAC, 60 Hz or a 220 VAC, 50 Hz outlet. The unit
automatically adjusts for 120V or 220V.
CAUTION: Proper grounding must be made to ensure the safe and proper operation of the unit.
The grounding pin on the power cord plug is connected to the Instalab enclosure. If an adapter with a grounding
wire is used, verify the grounding wire is connected to a good earth ground. Otherwise, a shock hazard may be
present. Do not use a 3-pin to a 2-pin adapter.
UNIT OVERVIEW
Figure 1
IL700
1
3
1) Power On/Off Button
2) Display
3) USB Connections
4) Sample Drawer
Appropriate space must be left around the input power connector to allow easy disconnection at the unit.
2
2
5
6
4
5) Vents
6) Power Outlet
7) Fan
8) Connections
External Communication Connections
- 4 USB Type A connections
(2 in front, 2 in back) for
connection to a keyboard, mouse,
7
printer or flash drive (only 3 USB
devices are supported at any
one time).
(1) RS232
8
Serial Port
Printer Connection
- 1 USB Type B connection to
(1) LAN
connect the IL700 to a PC for
(1) USB (B)
(2) USB (A)
downloading of software to the
device, installing calibrations, or
remotely accessing data from the
instrument
- 1 RS232 serial port connection
(9 pin)
- 1 ethernet LAN connection
Instalab 700 Quick Start Guide
11001-1608-201702 Rev B