- ページ 7

グリル Dickinson SEA-B-QUE LARGEのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Dickinson SEA-B-QUE LARGE 16 ページ。 Propane barbecue
Dickinson SEA-B-QUE LARGE にも：取扱説明書 (9 ページ), 取扱説明書 (10 ページ)

ページを印刷する

Getting to Know your Sea-B-Que

Thermometer:

The Large and Small Sea-B-Que are fitted with a thermometer. If you

remove the thermometer for cleaning or replacement, see below for re-

assembly diagram. Inspect the thermometer to ensure no small white bits of

plastic are around the edge, left over from the protective plastic used in the

manufacturing process. Be aware that bending or damaging the thermometer

probe or dropping the Sea-B-Que, may cause the thermometer to stop

working. (use #6 x ¼ screws)

Spark Igniter: (Large model only)

The igniter probe should be as close to the holes in the burner as possible.

See diagram below.

For a perfect fit, adjust the probe so that it is

3/16ths"(4.75mm) away from the holes. Igniters seldom fail but if yours

stops working try cleaning the probe. Built up grease may have coated the

probe, preventing the spark. Remove the igniter, clean the bracket and

around the base, the copper line on the side of the igniter and the screws.

Built up grease may have interrupted the ground. (use #8 x 3/8 screws & #8

nuts)

Orifice Assembly:

The orifice assembly is the series of brass fittings that attach to the gas

regulator control and go inside the end of the burner. The orifice has a tiny

hole that controls the maximum amount of fuel allowed to enter the burner.

From time to time salt or other debri may plug the hole changing the flame.

The Sea-B-Que will not get hot, and a blocked orifice may be the reason.

Remove and clean with a very small wire (twist tie). Do not expand the hole

or the Sea-B-Que will burn too hot.